Description

durateksupply.com DPC-B100 is a fast curing, hybrid polyurea, 100% solids, very low-VOC base coat for color quartz or vinyl mosaic flake broadcast. It comes pre-pigmented tan or grey for easy mixing and application. DPC-B100 is solvent-free and safe for interior applications. DPC-B100 is rapid curing allowing for fast project turn-around. ADVANTAGES • Very low odor • Fast curing, tack-free in 1 - 2 hours • Contains no solvents, safe interior applications • May be top-coated in 2 hours PACKAGING 3 US gal (18.9 L) or 15 US gal (3x5) (56.78 L) COLOR Pre-pigmented Tan or Grey Base Color RECOMMENDED THICKNESS2 10 mils (160 ft2/gal) SHELF LIFE 12 months in original unopened factory sealed container. Keep away from extreme cold, heat, or moisture. Keep out of direct sunlight and away from fire hazards. MIX RATIO, BY VOLUME Tan or Grey A:B = 2A : 1B POT LIFE, 16 oz (500g) MASS Winter Formula ~35 minutes @ 55o - 65oF (12.5 - 18.3oC) Summer Formula ~35 minutes @ 75o - 85oF (24.3 - 29.5oC) Tropical Formula ~35 minutes @ 85o - 95oF (29.5 - 35oC) VOC 8.6 g/l THINNING Not Recommended SOLIDS CONTENT BY WEIGHT 100% Surface Preparation: Concrete substrates should be cured for a minimum of 30 days and have a minimum compressive strength of 3,000 psi. Surfaces must be clean, sound and properly prepared. Suitable preparation methods are recirculating abrasive shot-blasting, and/or diamond abrasive grinding. Remove all surface contamination before preparation. All soil, grease, oil, wax, or curing-agents, must be removed. Any preparation method should produce a uniform surface profile of CSP-3 (ICRI Guide 03732,) or greater. Acid etching of concrete is unacceptable and will void Manufacturer’s warranty. Existing, well-adhered compatible coatings may be prepared by sanding or grinding to produce a uniformly open, gloss-free surface. Do not apply to wet or damp substrates. Test for concrete moisture before application (see Concrete Moisture.) Thoroughly vacuum prepared surface to remove all dust just prior to application. Protect prepared surface against contamination prior to application of product. Application: The recommended application method is the use of non-marking rubber squeegee and roller application. 18-inch rollers are recommended on larger area floors to reduce lap marks. Roller should have solvent-resistant phenolic core, high quality non-shedding fiber cover. Use 1/4-inch to 3/8-inch nap, depending on final finish and thickness desired. Quality brushes or wall-edgers may be used for cutting in margins. Distribute material evenly with non-marking (gray EPDM type, or similar) rubber flat squeegee. Apply an even film at the desired thickness. Roll material in two directions to achieve uniform film. Finish roll in one direction, typically at right angles to primary sight-line when entering room.